Black1

Prodotti, prezzi, dimensioni, possono subire variazioni senza preavviso, chiedere la conferma prima dell'ordine.

Prices, products, dimension, could be changed, Ask before order.

Black Gate (I)

Prezzi e prodotti aggiornati sul nuovo sito Audiokit e-Shop cliccando qui !

Update prices & products on new e-Shop Audiokit website click Here

The merits and demerits of the electrolytic capacitor which has the axial type of lead wires.
- If you don't know a real thing, you won't get the best result -

If you judge something by appearance only, you may misunderstand it because you don't know the inside of it.
In audio sets, there's one example. It's an electrolytic capacitor which has the axial type of lead wires.
This connecting way to a circuit is seen in a lot of vacuum tube amplifiers of amateurs made or garage makers'. The way of wiring was also used in an old telephone. It looks smart, therefore people tend to think its quality must be good. However, it's wrong as below.

Inside capacitor element is the same as an ordinary electrolytic cap which has the radial type of lead wires. The Lead wire of the negative side is welded spot to the one side of a flat ribbon wire that has more than 2L length, made of aluminum foil. Then the other side of the ribbon is also welded to the opposite side of an inside bottom. Its lead wire is made of iron because of the structural reason, therefore the element is connected by aluminum and iron to a circuit. However, these metals lower the quality for 30dB about the distortion value,and 30% about E.S.R. value. Especially the L-component of the earth side increases terribly, it reaches the worst level. Moreover, the connecting way is so unstable that is weak at vibration.

In short, this style is out of date, but many people still believe it today. We guess people are influenced by the appearance that looks easy connection or by its sales copy.
We asked many times if there will be a schedule of producing such type of electrolytic capacitor. However, we won't make it anytime in the future because of the above reasons.

Now, we're gonna introduce how to connect the radial type of a capacitor firmly to your hand made set. First, drill two holes in a PC board at an interval of the lead wires of the capacitor. Next, put eyelets into each of the hole. Then, glue the eyelets and the board with rubber adhesive. Finally, solder the root of the lead wires and the eyelets.

It will be better that to connect wireings and the lead wires. The lead wires become the shortest ones, moreover the glue is effective enough for suppressing the vibration of the electrodes.

We recommend you to connect BGs to a circuit with the way which we mentioned above. The tone quality will grade up fantastically that beyond your imagination.

Back Next

mercoledì 02 luglio 2014

go to AUDIOKIT Home Page